◔ Use with care in premature infants or infants under 2 months of age. These products may cause irritation or chemical burns.◔ Discard the Swab Stick after a single use.◔ The Foam is latex-free and for external use.◔ Use in a well-ventilated area.◔ Do not use for lumbar puncture or in contact with the meninges.◔ Do not use on open wounds or as a general skin cleanser.◔ Do not use on patients with known allergies to CHG or IPA.◔ Store between 15 to 30 ° C (59 to 86 ° F).◔ Keep the solution out of the eyes, ears and mouth.◔ Avoid freezing and excessive heat above 40 ° C (104 ° F). Store within the recommended conditions to maintain the efficacy

Product description:The head of IPA alcohol wiper is made of 100PPI polyurethane open-hole sponge, solvent resistant. The head has strong wiping ability and the rod body is made of transparent PP material.Made with IPA isopropyl alcohol stored in the body, gently squeeze the back end of PP rod. Due to the effect of IPA under air pressure, the solvent will overflow from the head and slowly penetrate into the sponge.Soak through a sponge head to wipe dirt off an object.Product use: Open the package, take out the cotton swab, squeeze the plastic rod, make the sponge head soak IPA. Hold the swab rod and wipe the product back and forth repeatedlyFeaturesColor: clear and colorless liquidPacking: 25 PCS/pack of 50 PCS/box of 5000 PCS/boxSize: Head width: 13mm Head thickness: 8.0mm Head length: 22mmRod width: 5.8mm Rod length: 87mm Total length: 109mmLiquid content: about 1.4ml, alcohol concentration is 99.9%Commodity material: head material imported sponge stem material polypropyleneFunction: IPA can effectively clean the ink and glue remaining on the printing head by cleaning the wiping stick and the high-density sponge head water and other dirt, can achieve a good decontamination effect.Commodity use: Used for cleaning the magnetic head of thermal printer. Printer nozzle, photo machine, hard disk, memory strip computer keyboard. Optical pool and magnetic head equipment, electronic components, thermal printers (punching machines, bar code printers, label printers and bill printers), inkjet printing

Step 1: Liquid secretions are rapidly absorbed between the perpendicular fibers by capillary action.Step 2: Rotate the swab two to three times and hold the swab in place for 5 seconds to ensure maximum absorbency. Strong capillary hydraulics between the strands of Nylon maximizes liquid sample collection.Step 3: Put the swab in the transport medium and break the shaft at the painted breakpoint. Sample elutes automatically and rapidly because it is held very close to the surface in a totally open structure. This does not hinder the flow dynamics, so the entire sample is released.

How to use the sticky mat ?1. Clean the floor where the mat be pasted to, until it get dry. and Peel off the  bottom sheet.2. Paste the sticky mat on the cleaned floor carefully and tidy the mat with a dry cloth, keep the mat paste smooth.3. Peel off the top sheet from the lable that be attached in the corner. Then start to use.4. When the first layer become dirty ,just peel off that sheet from the label,and then use the second layer.